Analysis of Steam Power Generators in Fulfilling Electricity Needs: A Case Study at PT Madubaru Yogyakarta, Indonesia

Danis Dwi Istiawan, Ramadoni Syahputra, Karisma Trinanda Putra

Abstract


This research was conducted to find out the amount of power produced by steam power generators and the amount of power needed for the operation of production motors in PT Madubaru Yogyakarta. This study also discusses the factors that support and inhibit the fulfillment of electric power in PT Madubaru Yogyakarta. From the results of the analysis that has been done, it can be seen that the power generated by the steam power generator at PT Madubaru Yogyakarta can meet the electricity needs of production motors in the factory. The power generated by the three steam generators at PT Madubaru amounts to 3,000 KW, while the power needed for the operation of production motors at the Milling Station, the Ketel Station, Central Factory Station, and Rear Factory Station is 2,313.54 KW. However, the production motor does not always turn on simultaneously, so the power needed is between 1,500 KW to 2,000 KW. The remaining power is used to anticipate an increase in electricity load.

Keywords


Steam power generator, Electricity needs, substation, peak load

Full Text:

Untitled

References


Syahputra, R., Soesanti, I., Ashari, M. (2016). Performance Enhancement of Distribution Network with DG Integration Using Modified PSO Algorithm. Journal of Electrical Systems (JES), 12(1), pp. 1-19.

Syahputra, R., Robandi, I., Ashari, M. (2015). Performance Improvement of Radial Distribution Network with Distributed Generation Integration Using Extended Particle Swarm Optimization Algorithm. International Review of Electrical Engineering (IREE), 10(2). pp. 293-304.

Syahputra, R., Robandi, I., Ashari, M. (2014). Optimization of Distribution Network Configuration with Integration of Distributed Energy Resources Using Extended Fuzzy Multi-objective Method. International Review of Electrical Engineering (IREE), 9(3), pp. 629-639.

Syahputra, R., Robandi, I., Ashari, M. (2015). Reconfiguration of Distribution Network with DER Integration Using PSO Algorithm. TELKOMNIKA, 13(3). pp. 759-766.

Syahputra, R., Soesanti, I. (2016). DFIG Control Scheme of Wind Power Using ANFIS Method in Electrical Power Grid System. International Journal of Applied Engineering Research (IJAER), 11(7), pp. 5256-5262.

Syahputra, R., Soesanti, I. (2015). Power System Stabilizer model based on Fuzzy-PSO for improving power system stability. 2015 International Conference on Advanced Mechatronics, Intelligent Manufacture, and Industrial Automation (ICAMIMIA), Surabaya, 15-17 Oct. 2015 pp. 121-126.

Syahputra, R., Soesanti, I. (2016). “Power System Stabilizer Model Using Artificial Immune System for Power System Controlling”. International Journal of Applied Engineering Research (IJAER), 11(18), pp. 9269-9278.

Syahputra, R. (2016). “Transmisi dan Distribusi Tenaga Listrik”. Yogyakarta : LP3M UMY Yogyakarta.

Nurmalita (2012), “Analisis Efisiensi Energy pada Pembangkit Listrik Tenaga Uap (PLTU) PT. Energi Alamraya Semesta di Kabupaten Nagan Raya Nanggroe Aceh Darussalam”, Thesis, Institit Pertanian Bogor.

Karaeng, C.T., Iswandi, Firman, Nuzul, M., (2012), “Analisis Kinerja Boiler pada PLTU Unit 1 PT. Semen Tonasa, Makassar”, PNUP.

Hanzen Yauri. K, Hardi. G, Benny. M, (2015), “Kajian Efisiensi Termal Dari Boiler Di Pembangkit Listrik Tenaga Uap Amurang Unit I”, Jurnal Online Poros Teknik Mesin, 4(2).

Jamal, A., Suripto, S., Syahputra, R., (2016), Performance Evaluation of Wind Turbine with Doubly-Fed Induction Generator, International Journal of Applied Engineering Research (IJAER), Vol. 11, No. 7.

Kadir, A. (1996), “Pembangkit Tenaga Listrik”, Universitas Indonesia, Jakarta.




DOI: https://doi.org/10.18196/jet.1425

Article Metrics

Abstract view : 18 times
Untitled - 17 times

Refbacks

  • There are currently no refbacks.



 

Office Address:

Journal of Electrical Technology UMY

Department of Electrical Engineering, Universitas Muhammadiyah Yogyakarta

Jl. Brawijaya, Kasihan, Bantul, Daerah Istimewa Yogyakarta

Phone/Fax: +62274-387656/ +62274-387646,

E-mail: ramadoni@umy.ac.id, jet@umy.ac.id