Perancangan Modifikasi Electric Hand Truck dengan Timing Belt untuk Jalan Bertangga

Jamal Muhammad Afiff, Tono Sukarnoto, Nico Siebert

Abstract


In today's industrial needs, the most common material handling equipment in daily uses is hand truck, because of the price itself is quite cheap, flexible, and easy to operate. However, one of the weaknesses of the hand truck is it can’t through places that have different heights such as stairs. To overcome this problem, the hand truck will be modified using a timing belt which make it possible the hand truck to pass through stairs. The design modification begins with collecting the main hand truck data, followed by making several design concepts, selecting the suitable design modification concept to overcome the staircase problem and finally analyzing and calculating the components used. Design modifications are illustrated in 3D shape using Solidworks software. The result of the modified design is an electric hand truck with a timing belt with dimensions of (1037 x 455 x 1102) mm for stair-climbing with a maximum angle of stair slope equal to 30 degrees which is able to lift a load of 100 kg at a speed of 0.8 m/s.


Keywords


hand truck, timing belt, Solidworks

Full Text:

PDF

References


S. Ray, Introduction to Material Handling, New Delhi: New Age International (P) Limited Publishers, 2008.

Suparno, Teknik Gambar Bangunan Jilid II, Direktorat Jenderal Manajemen Pendidikan Dasar dan Menengah, 2008.

V. C. Patil, C. Swapnil, G. Abhay, S. Niranjan and T. Virendra, “Design and Manufacturing of Automated Staicase Climbing Wheelchair Prototype by Using Belt Drive,” International Journal of Advance Research in Science and Engineering, vol. 07, no. 03, 2018.

Prestar, “Uesugi Product Guide Handtruck,” Osaka, 2020.

R. S. Khurmi and J. S. Gupta, A Textbook of Machine Design, New Delhi: Eurasia Publishing House (PVT.) LTD, 2005.

Sularso and K. Suga, Dasar Perencanaan dan Pemilihan Elemen Mesin, Jakarta: Pradnya Paramita, 2002.

A. Hughes, Electric Motor and Drives, Oxford: Elsevier Ltd., 2006.

Mitsuboshi, “Mitsuboshi Freespan Belt Catalogue,” Tokyo, 2021.

Mitsuboshi, “Design Manual Timing Belt,” Tokyo, 2020.

SKF, “Rolling Bearing Catalogue,” Gothenburg, 2018.

Tsubaki, “Tsubaki Drive and Chain Catalogue,” Osaka, 2013.




DOI: https://doi.org/10.18196/jmpm.v7i2.16194

Refbacks

  • There are currently no refbacks.


 

Editorial Office :

JMPM (Jurnal Material dan Proses Manufaktur)

Department of Mechanical Engineering, Faculty of Engineering, Universitas Muhammadiyah Yogyakarta.

Jl. Brawijaya Tamantirto Kasihan Bantul 55183 Indonesia

Email: jmpm@umy.ac.id

 (62)274-387656     (62)274-387656