Optimalisasi Parameter Proses Injeksi Menggunakan Simulasi Moldflow untuk Meminimalkan Cycle Time dan Eliminasi Short Shot pada Produk Tempat

M. Choirul Anwar, Cahyo Budiyantoro, Thoharudin Thoharudin

Abstract


Plastic materials in the manufacture of food and household appliances have been widely used by the public. Various forms and functions have been made, one of which is using an injection molding machine. With an injection molding machine a packaging design or a fairly complex household appliance can be produced. One of the products that the market is interested in is a traditional rice container. This traditional rice container product uses polypropylene material. In this rice container production process there are several problems, namely the cycle time that is too long and the occurrence of short shots on the product. Of these problems, simulations and optimizations that have been carried out provide better results. Optimization carried out in this study is the process parameters using moldflow simulation. Confirmation based on S / N Ratio analysis, ANOVA on the best parameters, after the optimization simulation is obtained from the previous time 172.59 seconds to 23.88 seconds. Short shot and cavity weight obtained increased from 96.99 grams to 99.36 grams.

Keywords


Injection molding, Moldflow insight, polypropylene, short shot, cycle time, Design of experiment

Full Text:

PDF

References


Ilmawati, C., Reza, M., Rahmatini dan Rustam E. Edukasi Pemakaian Plastik Sebagai Kemasan Makanan Dan Minuman Serta Risikonya Terhadap Kesehatan Pada Komunitas Di Kecamatan Bungus Teluk Kabung, Padang. Logista-Jurnal ilmiah pengabdian kepada masyarakat. 2017; 1: 20-28

Soejanto, I. “Desain Eksperimen dengan Metode Taguchi”. Yogyakarta: Graha Ilmu. 2009.

Chauhan, N. S., & Ahmad, S. Optimizing Cycle Time of Dvd-R Injection Moulding Machine. International Journal of Engineering Science and Technology. 2012; 4: 1982-1990.

Goodship V. Practical Guide To Injection Molding. Rapra Technology Limited. 2004.

Mehdi Moayyedian, Kazem Abhary, Romeo Marian. Gate design and filling process analysis of the cavity in injection molding process[J]. Advances in Manufacturing, 2016, 4(2): 123-133




DOI: https://doi.org/10.18196/jmpm.2121

Refbacks

  • There are currently no refbacks.


 


Editorial Office :

JMPM (Jurnal Material dan Proses Manufaktur)

Department of Mechanical Engineering, Faculty of Engineering, Universitas Muhammadiyah Yogyakarta.

Jl. Brawijaya Tamantirto Kasihan Bantul 55183 Indonesia

Email: jmpm@umy.ac.id

Telp/Fax: (62)274-387656    

Whatsapp: 085642095827