Simulasi Pengaruh Jarak Saddle Berbahan SA 516 Gr.70 pada Bejana Tekan Horizontal Menggunakan Software Autodesk Inventor 2019

Article Sidebar

PDF
Published: Mar 2, 2019
DOI: https://doi.org/10.18196/jmpm.2119
Keywords:
pressure vessel, saddle, tangent, finite element

Main Article Content

Krisdiyanto Krisdiyanto
Universitas Muhammadiyah Yogyakarta

Abstract

Pressure vessel is a complex structure. Pressure vessel is designed to resist internal pressure loads, temperature loads, external loads, etc. Horizontal pressure vessel is a type of pressure vessel. Horizontal pressure vessel is supported by two saddles. Saddle is used to hold loads from pressure vessel. Length variations saddle and tangent pressure vessel is affected to stress and displacement. Maximum stress values of pressure vessel should be considered so the failure of structure can be decreased. This research aims to review the effect length variations saddle and tangent pressure vessel to maximum stress and displacement.

Article Details

How to Cite
Krisdiyanto, K. (2019). Simulasi Pengaruh Jarak Saddle Berbahan SA 516 Gr.70 pada Bejana Tekan Horizontal Menggunakan Software Autodesk Inventor 2019. JMPM (Jurnal Material Dan Proses Manufaktur), 2(1), 35–42. https://doi.org/10.18196/jmpm.2119
Issue
Vol. 2 No. 1 (2018): Juni
Section
Articles

License

Creative Commons License


JMPM (Jurnal Material dan Proses Manufaktur) is licensed under a Creative Commons Attribution-ShareAlike 4.0 International License. You are free to :

  1. Adapt — remix, transform, and build upon the material for any purpose, even commercially.

The licensor cannot revoke these freedoms as long as you follow the license terms, which include the following:

  • Attribution — You must give appropriate credit, provide a link to the license, and indicate if changes were made. You may do so in any reasonable manner, but not in any way that suggests the licensor endorses you or your use.

  • ShareAlike — If you remix, transform, or build upon the material, you must distribute your contributions under the same license as the original.

References

Kumar, V., Kumar, N., Angra, S., dan Sharma, P. Design of Saddle Support for Horizontal Pressure Vessel, International Journal of Mechanical, Aerospace, Industrial and Mechatronics Engineering. 2014; 8: 1797-1801.

Seng, O. L. Analysis of Twin-Saddle-Supported Vessel Subjected to Non-Symmetric Loadings, Int. J. Pres Ves & Piping. 1988; 35: 423-437.

Yang, L., Weinberger, C., dan Shah, Y. T. Finite Element Analysis on Horizontal Vessels with Saddle Support, Computers & Structures. 1994; 52: 387-395.

Zick, L. P. Stresses in Large Horizontal Cylindrical Pressure Vessels on Two Saddle Support, The Welding Journal Research Supplement. 1951: 959-970.

Zore, A., dan Qaimi, M. G. Design and Optimization of Saddle for Horizontal Pressure Vessel, International Engineering Research Journal. 2015; 2: 4201-4204.