Pengaruh Diameter Katoda pada Sensitivitas Pengukuran Gradien Kecepatan dengan Metode Polarografi

Authors

  • Sukamta Sukamta Universitas Muhammadiyah Yogyakarta

DOI:

https://doi.org/10.18196/st.v11i2.762

Keywords:

polarography, electrochemical, cathode, gradient, flow

Abstract

Wall velocity gradient measurement using polarography gives very accurate output due to the absence of problem in fluid flow. Therefore this experiment is highly recommended. Based on the polarogram resulted in the polarography method, the potential that has to be applied to both electrode is 0.25 – 0.75 Volt, whilst in the experiment 0.45 is applied. Calibration has been done to single phase flow, by measuring as a result of  by friction between wall and current flow through electrode at constant flow rate. The ΔP data are used to determine τ. Relation plot between τ (resulted from ΔP measurement) and current can be obtained from the data acquisition device. The result of this research shows that the value of wall shear stress (as velocity gradient) is influenced by the increase of flow rate. Whilst measurement of wall shear stress shows that the cathode area gives effect on the sensitivity of the measurement,  a small cathode results in better shear stress data measurement (more sensitive). In this research the best wall shear stress was resulted in cathode with diameter d=0.2 mm.

Downloads

How to Cite

Sukamta, S. (2016). Pengaruh Diameter Katoda pada Sensitivitas Pengukuran Gradien Kecepatan dengan Metode Polarografi. Semesta Teknika, 11(2), 143–152. https://doi.org/10.18196/st.v11i2.762

Issue

Vol. 11 No. 2 (2008): NOVEMBER 2008

Section

Articles

License


Semesta Teknika is licensed under a Creative Commons Attribution 4.0 International License.

Authors who publish with this journal agree to the following terms:

  • Authors retain copyright and grant the journal right of first publication with the work simultaneously licensed under a Creative Commons Attribution License that allows others to share the work with an acknowledgement of the work's authorship and initial publication in this journal.
  • Authors are able to enter into separate, additional contractual arrangements for the non-exclusive distribution of the journal's published version of the work (e.g., post it to an institutional repository or publish it in a book), with an acknowledgement of its initial publication in this journal.
  • Authors are permitted and encouraged to post their work online (e.g., in institutional repositories or on their website) prior to and during the submission process, as it can lead to productive exchanges, as well as earlier and greater citation of published work (See The Effect of Open Access).