The Analysis of Comparison Electrical Power Measurement on LED Lamps
Abstract
Abstract— This study uses 2 variations of the value of the DC 12V LED lamp power that is 12W and 15W with 3 different brands of lamp variations. Measurement of input voltage and current is carried out using a Krisbow KW06-490 DC clampmeter that has been calibrated as a standard measuring instrument and a Krisbow KW06-491 DC clampmeter that has not been calibrated as a test gauge 1 and a Multimeter Viper DT830B that has not been calibrated as a test gauge 2. Data the current and input voltage between each lamp and different lamp brands are used to calculate the value of the test lamp power and then compare it.
The big conclusion from this study was found that the error value between the value of the test power or the use of DC 12V LED lamps with 12W written power on R, S, and T brand lamps was ± 51.67%, ± 70.75%, ± 61.33 %. In 15W lamps the brands R, S, and T were ± 7.20%, ± 0.53%, ± 8.27%.
Full Text:
PDFReferences
O. Caumont, P. Le Moigne, C. Rombaut, X. Muneret, and P. Lenain, “Energy gauge for lead-acid batteries in electric vehicles,” IEEE Trans. Energy Convers., vol. 15, no. 3, pp. 354–360, 2000.
B. Szabados and A. Mihalcea, “Design and implementation of a calorimetric measurement facility for determining losses in electrical machines,” IEEE Trans. Instrum. Meas., vol. 51, no. 5, pp. 902–907, 2002.
C. Landi, M. Luiso, and N. Pasquino, “A Remotely Controlled Onboard Measurement System for Optimization of Energy Consumption of Electrical Trains,” IEEE Trans. Instrum. Meas., vol. 57, no. 10, pp. 2250–2256, Oct. 2008.
A. M. Yassine, T. M. Chen, and M. Bordelon, “Resistance transients in Al-based thin films and activation energy measurements,” IEEE Trans. Electron Devices, vol. 45, no. 11, pp. 2375–2378, 1998.
A. D. Femine, D. Gallo, C. Landi, and M. Luiso, “Advanced Instrument For Field Calibration of Electrical Energy Meters,” IEEE Trans. Instrum. Meas., vol. 58, no. 3, pp. 618–625, Mar. 2009.
Yonghua Cheng, “Assessments of Energy Capacity and Energy Losses of Supercapacitors in Fast Charging–Discharging Cycles,” IEEE Trans. Energy Convers., vol. 25, no. 1, pp. 253–261, Mar. 2010.
S. G. Ghalamestani, T. G. D. Hilgert, L. Vandevelde, J. J. J. Dirckx, and J. A. A. Melkebeek, “Magnetostriction Measurement by Using Dual Heterodyne Laser Interferometers,” IEEE Trans. Magn., vol. 46, no. 2, pp. 505–508, Feb. 2010.
M. J. Moser, T. Bretterklieber, H. Zangl, and G. Brasseur, “Strong and weak electric field interfering: Capacitive icing detection and capacitive energy harvesting on a 220-kV high-voltage overhead power line,” IEEE Trans. Ind. Electron., vol. 58, no. 7, pp. 2597–2604, 2011.
G. Bucci, E. Fiorucci, F. Ciancetta, D. Gallo, C. Landi, and M. Luiso, “Embedded power and energy measurement system based on an analog multiplier,” IEEE Trans. Instrum. Meas., vol. 62, no. 8, pp. 2248–2257, 2013.
C. L. Holloway et al., “Broadband Rydberg atom-based electric-field probe for SI-traceable, self-calibrated measurements,” IEEE Trans. Antennas Propag., vol. 62, no. 12, pp. 6169–6182, 2014.
S. V. Gubbi and B. Amrutur, “All Digital Energy Sensing for Minimum Energy Tracking,” IEEE Trans. Very Large Scale Integr. Syst., vol. 23, no. 4, pp. 796–800, Apr. 2015.
F. Adamo, F. Attivissimo, G. Cavone, A. Di Nisio, and M. Spadavecchia, “Channel characterization of an open source energy meter,” IEEE Trans. Instrum. Meas., vol. 63, no. 5, pp. 1106–1115, 2014.
D. Lindenthaler and G. Brasseur, “Signal-Bandwidth Evaluation for Power Measurements in Electric Automotive Drives,” IEEE Trans. Instrum. Meas., vol. 64, no. 6, pp. 1336–1343, 2015.
P. C. Dias, F. J. O. Morais, M. B. de Morais Franca, E. C. Ferreira, A. Cabot, and J. A. Siqueira Dias, “Autonomous Multisensor System Powered by a Solar Thermoelectric Energy Harvester With Ultralow-Power Management Circuit,” IEEE Trans. Instrum. Meas., vol. 64, no. 11, pp. 2918–2925, Nov. 2015.
Y. Tsunoda et al., “A Small-Size Energy-Harvesting Electric Power Sensor for Implementing Existing Electrical Appliances Into HEMS,” IEEE Sens. J., vol. 16, no. 2, pp. 457–463, 2016.
N. Alatawneh and P. Pillay, “Calibration of the Tangential Coil Sensor for the Measurement of Core Losses in Electrical Machine Laminations,” IEEE Trans. Energy Convers., vol. 31, no. 2, pp. 413–423, 2016.
B. Qi, X. Zhao, and C. Li, “Methods to reduce errors for DC electric field measurement in oil-pressboard insulation based on Kerr-effect,” IEEE Trans. Dielectr. Electr. Insul., vol. 23, no. 3, pp. 1675–1682, 2016.
C. Trigona, B. Andò, S. Baglio, R. La Rosa, and G. Zoppi, “Sensors for Kinetic Energy Measurement Operating on ‘Zero-Current Standby,’” IEEE Trans. Instrum. Meas., vol. 66, no. 4, pp. 812–820, 2017.
W. Yao, Y. Zhang, Y. Liu, M. J. Till, and Y. Liu, “Pioneer design of non-contact synchronized measurement devices using electric and magnetic field sensors,” IEEE Trans. Smart Grid, vol. 9, no. 6, pp. 5622–5630, 2018.
I. S. Kwon, J. Y. Na, H. Y. Lee, and B. W. Lee, “Determination of Threshold Electric Field for PPLP Specimen in Liquid Nitrogen Based on the Measurement of Electrical Conductivity,” IEEE Trans. Appl. Supercond., vol. 28, no. 3, pp. 1–4, 2018.
W. Liu, C. Tan, X. Dong, F. Dong, and Y. Murai, “Dispersed Oil-Water Two-Phase Flow Measurement Based on Pulse-Wave Ultrasonic Doppler Coupled with Electrical Sensors,” IEEE Trans. Instrum. Meas., vol. 67, no. 9, pp. 2129–2142, 2018.
S. Chamanian, S. Baghaee, H. Ulusan, O. Zorlu, E. Uysal-Biyikoglu, and H. Kulah, “Implementation of Energy-Neutral Operation on Vibration Energy Harvesting WSN,” IEEE Sens. J., vol. 19, no. 8, pp. 3092–3099, 2019.
G. Crotti et al., “Pantograph-To-OHL Arc: Conducted Effects in DC Railway Supply System,” 9th IEEE Int. Work. Appl. Meas. Power Syst. AMPS 2018 - Proc., vol. 68, no. 2, pp. 3861–3870, 2018.
M. Raeiszadeh and F. Taghipour, “Microplasma UV lamp as a new source for UV-induced water treatment: Protocols for characterization and kinetic study,” Water Res., vol. 164, p. 114959, 2019.
S. Mehran, M. Nikian, M. Ghazi, H. Zareiforoush, and I. Bagheri, “Experimental investigation and energy analysis of a solar-assisted fluidized-bed dryer including solar water heater and solar-powered infrared lamp for paddy grains drying,” Sol. Energy, vol. 190, no. March, pp. 167–184, 2019.
W. Do et al., “Effect of flash lamp annealing on electrical activation in boron-implanted polycrystalline Si thin films,” Mater. Res. Bull., vol. 58, pp. 164–168, 2014.
C. De Santi et al., “Failure causes and mechanisms of retrofit LED lamps,” Microelectron. Reliab., vol. 55, no. 9–10, pp. 1765–1769, 2015.
M. Cai et al., “Step-stress accelerated testing of high-power LED lamps based on subsystem isolation method,” Microelectron. Reliab., vol. 55, no. 9–10, pp. 1784–1789, 2015.
C. Stegner, M. Dalsass, P. Luchscheider, and C. J. Brabec, “Monitoring and assessment of PV generation based on a combination of smart metering and thermographic measurement,” Sol. Energy, vol. 163, no. February, pp. 16–24, 2018.
W. L. Rodrigues Junior, F. A. S. Borges, A. F. da S. Veloso, R. de A. L. Rabêlo, and J. J. P. C. Rodrigues, “Low voltage smart meter for monitoring of power quality disturbances applied in smart grid,” Measurement, vol. 147, p. 106890, 2019.
S. Sureshkumar et al., “Utilization of eddy current flow meter for sodium flow measurement in FBRs,” Nucl. Eng. Des., vol. 265, pp. 1223–1231, 2013.
R. W. Herschy, “The uncertainty in a current meter measurement,” Flow Meas. Instrum., vol. 13, no. 5–6, pp. 281–284, 2002.
M. M. Othman, M. H. Ahmed, and M. M. A. Salama, “A novel smart meter technique for voltage and current estimation in active distribution networks,” Int. J. Electr. Power Energy Syst., vol. 104, no. February 2018, pp. 301–310, 2019.
D. B. Avancini, J. J. P. C. Rodrigues, S. G. B. Martins, R. A. L. Rabêlo, J. Al-Muhtadi, and P. Solic, “Energy meters evolution in smart grids: A review,” J. Clean. Prod., vol. 217, pp. 702–715, 2019.
F. Abate, M. Carratù, C. Liguori, and V. Paciello, “A low cost smart power meter for IoT,” Meas. J. Int. Meas. Confed., vol. 136, pp. 59–66, 2019.
G. van de Kaa, T. Fens, J. Rezaei, D. Kaynak, Z. Hatun, and A. Tsilimeni-Archangelidi, “Realizing smart meter connectivity: Analyzing the competing technologies Power line communication, mobile telephony, and radio frequency using the best worst method,” Renew. Sustain. Energy Rev., vol. 103, no. January 2017, pp. 320–327, 2019.
F. Ni, P. H. Nguyen, J. F. G. Cobben, H. E. Van den Brom, and D. Zhao, “Three-phase state estimation in the medium-voltage network with aggregated smart meter data,” Int. J. Electr. Power Energy Syst., vol. 98, no. October 2017, pp. 463–473, 2018.
Y. Wang, H. Qiu, Y. Tu, Q. Liu, Y. Ding, and W. Wang, “A review of smart metering for future Chinese grids,” Energy Procedia, vol. 152, pp. 1194–1199, 2018.
N. A. Funde, M. M. Dhabu, A. Paramasivam, and P. S. Deshpande, “Motif-based association rule mining and clustering technique for determining energy usage patterns for smart meter data,” Sustain. Cities Soc., vol. 46, no. November 2018, p. 101415, 2019.
C. Stegner, O. Glaß, and T. Beikircher, “Comparing smart metered, residential power demand with standard load profiles,” Sustain. Energy, Grids Networks, vol. 20, p. 100248, 2019.
DOI: https://doi.org/10.18196/jrc.1425
Refbacks
- There are currently no refbacks.
Copyright (c) 2020 Journal of Robotics and Control
This work is licensed under a Creative Commons Attribution-ShareAlike 4.0 International License.
Journal of Robotics and Control (JRC)
P-ISSN: 2715-5056 || E-ISSN: 2715-5072
Organized by Peneliti Teknologi Teknik Indonesia
Published by Universitas Muhammadiyah Yogyakarta in collaboration with Peneliti Teknologi Teknik Indonesia, Indonesia and the Department of Electrical Engineering
Website: http://journal.umy.ac.id/index.php/jrc
Email: jrcofumy@gmail.com