Low Power NAND Gate–based Half and Full Adder / Subtractor Using CMOS Technique
Abstract
In recent years, low power consumption has been an important consideration for the design of system since there is a high demand for consumer electronics such as cellphones for a longer battery life. This paper presents the simulation of half adder, half subtractor, full adder, and the full subtractor. The presented circuit contains NAND gates combining the NMOS and PMOS. These CMOS circuitries has the advantage of lower voltage, lower power consumption, and higher energy efficiency. The NMOS and PMOS were bridge together to produce the desired output. This design provides the CMOS half adder, half subtractor, full adder, and full subtractor using the Tanner EDA software tool. The complete CMOS circuit schematic are described in this paper. The design methods and principles are described thereafter. Simulations have been done with the use of the Tanner EDA tool in a CMOS technology standard and response output was verified comparing the obtained waveform along with its truth table. In comparison with conventional logic truth table, T-Spice output simulation matches with theoretical expectations.
Keywords
Full Text:
PDFReferences
M. Alioto, G. Palumbo, and M. Poli, “Energy consumption in RC tree circuits,” IEEE Transactions on Very Large Scale Integration (VLSI) Systems, vol. 14, no. 5, pp. 452–461. July 2006.
A. Wiltgen, K. A. Escobar, A. I. Reis, and R. P. Ribas, “Power consumption analysis in static CMOS gates,” in 26TH Symposium on Integrated Circuits and Systems Design (SBCCI), pp. 1–6, Curitiba, Brazil, September 2013.
T. Wilmshurst, Designing Embedded Systems with PIC Microcontrollers 2ed, 584 pages, Newnes, USA, November 2006. ISBN -13: 978-0750667555
A. A. Beltran Jr., Z. Lontoc, B. Conde, R. Serfa Juan, and J. R. Dizon, World Congress on Engineering and Technology; Innovation and Its Sustainability 2018, Springer, Switzerland, September 2019. ISBN 978-3-030-20903-2
M. H. Rashid, Microelectronic Circuits: Analysis and Design 3ed, 1360 pages, Cengage Learning, USA, January 2016. ISBN -13: 978-1305635166
B. B. Rajesh, S. Nagraj, and M. K. Chaitanya, “Full adder using CMOS technology,” International Journal of Advanced Trends in Engineering, Science and Technology, vol. 4, special issue no. 1, pp. 208–211. December 2016.
P. K. D. Gayathri, P. Harini, and P. T. Rani, “Design of low power 1-bit full adder using variable sub-threshold voltage at 45nm technology,” International Journal of Advanced Research in Electrical Electronics and Instrumentation Engineering, vol. 6, no. 3, pp. 2042–2052. March 2017.
A. Kumar and A. K. Goyal, “Study of various full adders using Tanner EDA tool,” International Journal of Computer Science and Technology, vol. 3, no. 1, pp. 581–585. March 2017.
P. Sharma and A. Sharma, “Design and analysis of power efficient PTL half subtractor using 120nm technology,” International Journal of Computer Trends and Technology, vol. 7, no. 4, pp. 207–213. January 2014.
T. S. Monikashree, S. Usharani, and J. S. Baligar, “Design and implementation of full subtractor using CMOS 180nm technology,” International Journal of Science, Engineering and Technology Research, vol. 3, no. 5, pp. 1421–1426. May 2014.
R. Bukkal and P. Dimri, “1-bit full subtractor using CMOS technique and GDI technique using Tanner EDA tool,” International Journal for Scientific Research and Development, vol. 3, no. 4, pp. 1508–1510. July 2015.
G. H. Kumar, K. Gopi, P. Gowtham, and G. N. Balaji, “Area efficient full subtractor based on static 125nm CMOS technology,” International Journal of Trend in Scientific Research and Development, vol. 2, no. 6, pp. 1371508–1510. July 2015.
A. A. Beltran Jr., C. D. Hiwatig, N. J. R. Laguna–Agustin, and M. B. Villanueva, “Teaching electronic circuits using altium designer,” International Journal of Scientific Engineering and Technology, vol. 3, no. 10, pp. 1239–1243, October 2014.
A. A. Beltran Jr., “Design of a linear integrated op amp circuit: an alternative solution to differential equation model of RLC circuit,” Lyceum of the Philippines University Research Journal, vol. 2, no. 1, pp. 49–65, June 2007.
A. A. Beltran Jr., “Speed control of a three-phase alternating current induction motor using space vector pulse width modulation,” International Journal of Scientific Engineering and Technology, vol. 3, no. 4, pp. 380–384, April 2014.
A. A. Beltran Jr., “Direct torque control based space vector pulse width modulation of a two level inverter fed three phase alternating current induction motor using Matlab/Simulink,” Institute of Electronics Engineers of the Philippines (IECEP) Journal, vol. 1, no. 1, pp. 27–36, July 2012.
M. J. P. Diaz, C. E. A. Mariano, and A. A. Beltran Jr., “Accelerometer-based Wave Motion Compensation on Ship Mounted Weaponry,” International Journal of Scientific Engineering and Technology, vol. 3, no. 5, pp. 588–591, May 2014.
A. A. Beltran Jr. and M. R. Bernardo, “Design and implementation of low power half duplex embedded chip to chip communication via microwire bus interface,” Institute of Electronics Engineers of the Philippines (IECEP) Journal, vol. 1, no. 1, pp. 19–26, July 2012.
R. E. Tolentino, R. I. A. Casil, B. G. Nia, and A. A. Beltran Jr., “Robotic elbow movement angular position improvement using kalman filter,” Institute of Electronics Engineers of the Philippines (IECEP) Journal, vol. 3, no. 1, pp. 68–73, May 2014.
A. A. Beltran Jr., R. E. Tolentino, N. C. Javier, and H. Zhang, “MCU-based robotic elbow movement control,” International Journal of Scientific Engineering and Technology, vol. 4, no. 8, pp. 438–442, August 2015.
A. A. Beltran Jr., C. D. T. Cayao, J. K. V. Delicana, and B. B. Agraan Jr., “Reduced image noise on shape recognition using singular value decomposition for pick and place robotic system,” International Journal of Scientific Engineering and Technology, vol. 3, no. 4, pp. 385–389, April 2014
A. A. Beltran Jr. and F. S. Caluyo, “Design and implementation of fuzzy logic controlled uninterruptible power supply integrating renewable solar energy,” International Journal of Engineering Research, vol. 3, no. 3, pp. 162–166, March 2014.
A. A. Beltran Jr., “Standalone solar PV maximum power point tracking using interval type 2 fuzzy logic,” in IEEE Eurasia Conference on IoT, Communication and Engineering 2019, pp. 534–537, Yunlin, Taiwan, October 2019.
Y. Y. Hong, A. A. Beltran Jr., and A. C. Paglinawan, “Real-time simulation of maximum power point tracking control using fuzzy logic for standalone PV system,” in IEEE 3RD International Future Energy Conference and ECCE Asia 2017, pp. 710–715, Kaohsiung, Taiwan, June 2017.
M. A. Z. Amador, M. A. C. Lina, A. G. Aquino, F. A. Gutteres, A. U. Ganggangan, and A. A. Beltran Jr., “Design and implementation of power management system utilizing supercapacitors for hybrid vehicles,” International Journal of Scientific Engineering and Technology, vol. 3, no. 8, pp. 1074–1077, August 2014.
G. Mappatao, I. M. Z. Bautista, M. K. Orsos, M. A. Ribo, and J. Castillo, “Development of a remote tending system for analog broadcast transmitters,” Indonesian Journal of Electrical Engineering and Computer Science, vol. 15, no. 3, pp. 1474–1484, September 2019.
G. Mappatao, I. M. Z. Bautista, M. K. Orsos, M. A. Ribo, and J. Castillo, “Remote tending of modern broadcast transmitters,” Indonesian Journal of Electrical Engineering and Computer Science, vol. 15, no. 3, pp. 1491–1500, September 2019.
A. C. Paglinawan, L. C. Valiente, A. A. Beltran Jr., A. V. Mabalot, J. A. Verdida, and C. L. D. Marte, “Wireless power transfer using near field communication for mobile devices,” in IEEE 3rd International Future Energy Electronics Conference and ECCE Asia 2017, pp. 1747 – 1752, Kaohsiung, Taiwan, June 2017.
A. A. Beltran Jr., F. I. Alano, V. B. Alvarez, R. J. D. Habab, and P. M. P. Buay, “A simulation research in linear beam forming transmission,” International Journal of Scientific Engineering and Technology, vol. 3, no. 12, pp. 1431 – 1435, December 2014.
A. A. Beltran Jr., G. Tan, S. Y. Castriciones, K. Cuerdo, A. Valdez, and J. J. Vega, “Design and implementation of an emergency datacasting system using 2-meter amateur radio band,” in IEEE International Conference on Smart Technology and Applications 2020, pp. 1–5, Surabaya, Indonesia, February 2020.
A. U. Ganggangan, A. A. Beltran Jr., E. C. Barreto, P. F. Hernandez, P. E. P. De Villa, and M. T. A. M. Cabatac, “Chest worn pulse oximeter integrating NI USRP with GPS disciplined clock transmitter,” International Journal of Scientific Engineering and Technology, vol. 4, no. 1, pp. 10 – 14, January 2015.
A. A. Beltran Jr., “A new lorenz unlike chaotic attractor,” in 2nd International E-Conference on Emerging Trends in Technology 2014, pp. 16–23, Bhopal, India, February 2014.
A. A. Beltran Jr., A. C. Clavero, J. M. B. De Vera, P. A. P. Lopez, C. A. Mueca, N. A. Pempena IX, and A. Z. D. Roxas, “Arduino based food and water dispenser for pets with GSM technology control,” International Journal of Scientific Engineering and Technology, vol. 3, no. 4, pp. 231 – 234, April 2014.
J. M. M. Baroro, M. I. Alipio, M. L. T. Huang, T. M. Ricamara, and A. A. Beltran Jr., “Automation of packaging and material handling using programmable logic controller,” International Journal of Scientific Engineering and Technology, vol. 3, no. 6, pp. 767–770, June 2014.
J. L. G. Medialdea, M. E. C. Manamparan, M. G. M. Sorita, E. L. Ponce, and A. A. Beltran Jr., “A novel thermal gas analyzer using adaptive neuro-fuzzy inference system (ANFIS),” Institute of Electronics Engineers of the Philippines (IECEP) Journal, vol. 2, no. 1, pp. 27–31, June 2013.
R. I. A. Casil, E. D. Dimaunahan, M. E. C. Manamparan, B. G. Nia, and A. A. Beltran Jr., “A DSP based vector quantized mel frequency cepstrum coefficients for speech recognition,” Institute of Electronics Engineers of the Philippines (IECEP) Journal, vol. 3, no. 1, pp. 1–5, May 2014.
DOI: https://doi.org/10.18196/jrc.2487
Refbacks
- There are currently no refbacks.
Copyright (c) 2020 Journal of Robotics and Control (JRC)
This work is licensed under a Creative Commons Attribution-ShareAlike 4.0 International License.
Journal of Robotics and Control (JRC)
P-ISSN: 2715-5056 || E-ISSN: 2715-5072
Organized by Peneliti Teknologi Teknik Indonesia
Published by Universitas Muhammadiyah Yogyakarta in collaboration with Peneliti Teknologi Teknik Indonesia, Indonesia and the Department of Electrical Engineering
Website: http://journal.umy.ac.id/index.php/jrc
Email: jrcofumy@gmail.com